ĪIR BAG MODULE : Passenger air bag module
#B0020 13 LEFT SIDE SEAT DEPLOYMENT SQUIB 1 DRIVER#
Driver air bag inflates by breaking steering wheel center pad surface.Driver air bag module mainly consists of air bag.Driver air bag module is built into steering wheel.After air bag inflates, the instrument panel assembly should be replaced if damaged.Conduct self-diagnosis to check entire SRS for proper functioning after replacing any components.Always place driver and passenger air bag modules with the pad side facing upward and seat mounted side air bag module standing with the stud bolt side facing down. Wheel and column after removal of steering gear. The spiral cable must be aligned in the neutral position since its rotations are limited.Also check diagnosis sensor unit for cracks, deformities or rust before installation and replace as required. Diagnosis sensor unit must always be installed with their arrow marks “⇐” pointing towards the front of the.Therefore, never work on any SRS connectors or wires until at least 3 minutes have Before servicing the SRS, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3įor approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pretensioner to deploy.Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.Replace occupant classification system control unit and passenger front seat cushion as an assembly. When using air or electric power tools or hammers, always switch the ignition OFF, disconnect theīattery, and wait at least 3 minutes before performing any service.Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing Ignition ON or engine running, never use air or electric power tools or strike near the sensor(s) withĪ hammer. When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the.PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness
Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual.Injury caused by unintentional activation of the system. Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal.The event of a collision that would result in air bag inflation, all maintenance must be performed by To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in.Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” of thisĪlways observe the following items for preventing accidental activation.
System uses the seat belt switches to determine the front air bag deployment, and may only deploy one frontĪir bag, depending on the severity of a collision and whether the front occupants are belted or unbelted. This system includes seat belt switch inputs and dual stage front air bag modules. With a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along C Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT 5ĪIR BAG MODULE : Curtain air bag module. 4ĪIR BAG MODULE : Passenger air bag module. (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER". Precaution for Supplemental Restraint System 10įOR FRONTAL COLLISION : When SRS is activated in a collision.
0 kommentar(er)
